9
Assembling the Grass Bags
Parts needed for this procedure:
2
Bag frame
2
Grass bag
Procedure
Snap the 2 bag frames to the 2 grass bags.
g453040
Figure 19
10
Installing the Bagger T op
Parts needed for this procedure:
2
Grass bag assembly
Procedure
1. Install the bagger top to the bagger frame.
Note: Y our bagger may look dif ferent than the
one shown.
2. Slide the brackets over the posts in the bagger
frame and install the circular cotter pin into the
hole in the right hand post ( Figure 20 ).
3. Rotate the bagger hood down to the operating
position.
Note: T o remove the circular cotter pin,
continue to rotate it in the same direction as
installed.
g016265
Figure 20
1. Bagger hood
4. Circular cotter pin
2. Bagger frame
5. Post
3. Bracket, bagger hood
15
To Next Page
Loading...
