5
Installing the Pulley
Assembly , Belt Cover ,
and Shoulder Bolt
Parts needed for this procedure:
1 Pulley assembly
1 Belt cover
Procedure
1. Remove the nut and washer from the right
mower deck pulley .
2. Install the pulley assembly to the right mower
deck pulley with the previously removed nut and
washer ( Figure 10 ).
Important: For 48-inch mower decks, use
the small blower pulley .
For 54-inch and 60-inch mower decks, use
the large blower pulley .
3. T orque the nut to 136 to 149 N∙m (100 to 1 10
ft-lb).
g201880
Figure 10
54-inch mower deck shown
1. Existing pulley nut
4. Existing deck (spindle)
pulley
2. Existing washer
5. Spindle
3. Blower pulley
4. Install the new belt cover over the pulley
assembly using the 4 previously removed
screws (1/4 x 1/2 inch) as shown in Figure 1 1 .
g201435
Figure 1 1
1. Belt cover
2. Screw (1/4 x 1/2 inch)
6
Installing the Attachment
Mount
Parts needed for this procedure:
1
Stabilizer bracket
1
Bagger frame
6
Bolt (5/16 x 1 inch)
6
Locknut (5/16 inch)
1
Pivot frame
1 Long clevis pin
3 Hairpin
2
Clevis pin
2 Rod
2 W asher
Procedure
1. Remove the existing 2 bolts, 2 nuts, and hitch
bracket from the bottom of the rear guard ( Figure
12 ).
1 1
To Next Page
Loading...
