Toro TITAN 79348 - Page 12

g465961
Figure 12
1. Nut 3. Bolt
2. Existing hitch bracket
2. Install the stabilizer bracket to the rear guard
using 2 bolts (5/16 x 1 inch) and 2 locknuts (5/16
inch) as shown in Figure 13 .
g462070
Figure 13
1. Locknut (5/16 inch) 3. Bolt (5/16 x 1 inch)
2. Stabilizer bracket
3. Install the bagger mount bracket to the machine
as shown in Figure 14 .
g462069
Figure 14
1. Locknut (5/16 inch) 3. Bolt (5/16 x 1 inch)
2. Bagger mount bracket
4. Install the bagger frame to the bagger mount
bracket using the long clevis pin and a hairpin
( Figure 15 ).
g462458
Figure 15
1. Clevis pin 3. Bagger frame
2. Hairpin
5. Install the bent, ared end of a rod into the
keyed slot in the side of the machine frame, and
move the rod rearward to seat it in the frame
( Figure 16 ).
12