Toro TITAN 79348 - Installing the Baffle and Blower Support

g466323
Figure 5
1. Rod
4. Deector
2. Cotter pin (CE models
only)
5. Deck brackets
3. Spring 6. Spring installed over the
rod
3. Remove the deector ( Figure 5 ).
4. Pull up the side of the cover with the grommet
and slide the cover of f. ( Figure 6 ).
g454740
Figure 6
4
Installing the Bafe and
Blower Support
Parts needed for this procedure:
1 Blower support
2
Hex washer-head screw (3/8 x 3/4 inch)
1
Baf e
4
Carriage bolt (5/16 x 3/4 inch)
4
Flange nut (5/16 inch)
Procedure
1. Install the blower support to the mower deck
using 2 hex washer-head screws (3/8 x 3/4 inch)
as shown in Figure 7 .
g201299
Figure 7
1. Hex washer-head screw
(3/8 x 3/4 inch)
2. Blower support
9