Toro TITAN 79348 - Removing the Grass Deflector and Belt Cover

g462067
Figure 3
1. Right weight-mount
3. Locknut (3/8 inch)
2. Bolt (3/8 x 1 inch) 4. Left weight-mount
2. Install the bagger weights (amount determined
by deck size) to the weight mounting bracketsto
the weight mounts with 2 bolts (3/8 x 2-3/4
inches), washers, and locknuts (3/8 inch) as
shown in Figure 4 .
Deck Size Plates Required*
48-inch 3
54-inch 2
60-inch 1
Important: Adjust the amount of weight
according to the size of the mower deck.
g462068
Figure 4
1. Bolt (3/8 x 2-3/4 inches)
3. Bagger weights
2. W asher
4. Locknut (3/8 inch)
3
Removing the Grass
Deector and Belt Cover
No Parts Required
Procedure
W ARNING
An uncovered discharge opening could allow
the machine to throw objects toward you or
bystanders and result in serious injury . Also,
contact with the blade could occur .
Never operate the lawn mower unless you
install a mulch plate, discharge deector , or
grass-collection system.
Inspect the grass deector for damage before each
use. Replace any damaged parts before use.
1. Set the height of cut at the lowest cutting
position.
2. Disengage the spring from the notch in the
deector bracket and remove the cotter pin (CE
models only), slide the rod out of the welded
deck brackets, spring, and discharge deector
( Figure 5 ).
Note: Y our chute may look dif ferent than the
one pictured.
8