Note: Repeat this step for both sides of the
machine.
6. With the rod fully seated in the frame, adjust the
position of the clevis at the end of the rod so
it aligns with the tab on the side of the bagger
frame.
g462501
Figure 16
Left side shown
1. Rod fully seated in the
frame
2. Clevis adjusted to the side
of the bagger frame
7. Secure the ends of the rods to the bagger frame
as shown in Figure 16 and secure the end of
each rod with a clevis pin and a hairpin.
7
Installing the Latch Rod
Parts needed for this procedure:
1 Latch rod
1 Hairpin cotter
Procedure
Install the latch rod with a hairpin cotter ( Figure 17 ).
g465962
Figure 17
1. Hairpin cotter 3. Latch rod hole
2. Latch rod
13
To Next Page
Loading...
