HYDROSTATIC DRIVE SYSTEM
7-152007 - 2008 Titan Z Service Manual
7
6. Plug the wire harness plug onto the left neutral
switch (Fig. 407).
5. Install the motion control damper screw through the
left hand motion control pivot assembly. Install a nut
to secure (Fig. 406).
Fig. 406 IMG-0480a
Fig. 407 IMG-0522a
7. Install two screws and washers retaining the left
hand lever grip assembly to the lever mount post
(Fig. 408).
Fig. 408 IMG-0523a
8. Left Hand Motion Control Pivot: Install the left hand
fender and fuel tank. Refer to “Left Hand Fender and
Fuel Tank Installation” on page 3-10
Right Hand Motion Control Pivot: Install the right
hand fender. Refer to “Right Hand Fender Install-
ation” on page 3-17.
To Next Page
Loading...
