8
To Set Calendar Days:
1. Turn the Function Dial to Calendar Days .
2. Sunday will be displayed and selected to water indicated by the water icon. To exclude the
day from the schedule, press the or button to display the No Water icon.
3. Press the button to select the next day.
4. Repeat step 2 and 3 to schedule the remaining days of the week.
To Set Odd or Even Days:
1. Turn the Function Dial to the Odd/Even position.
2. Press the or button to select ODD or EVEN.
3. To exclude specific days from watering, press the button to select the day.
4. To exclude the day from the schedule, press the or button to display the No Water
icon.
5. To exclude additional days (7 maximum), repeat steps 4 and 5.
To Set Interval Days:
1. Turn the Function Dial to Interval Days .
2. The CYCLE LENGTH prompt and the current Interval (01–31 DAY or -- -- -- [Off]) will be
displayed.
3. Press the or button to select the Interval cycle length.
NOTE: The cycle length can be set from 01 (water every day) to 31 (water once every 31 days).
The Interval cycle starts at 01 and increases by 1 digit each day. The watering day occurs when
the selected Interval cycle length is reached.
To specify when the first watering day will occur, the current day within the Interval cycle must be
selected. For example, if a 04 DAY Interval is entered and watering is to begin in one day, select
03 as the Current Day.
4. To select the Current Day in the Interval cycle, press the
button to display the
CURRENT DAY prompt.
5. Press the or button to select the value (01–selected Interval number).
6. To exclude specific days from watering (7 maximum), press the
button to select the day.
7. To exclude the day from the schedule, press the or button to display the
No Water icon.
8. Repeat steps 6 and 7 to continue excluding days.
STOP – This concludes the basic program setup procedures. Repeat these procedures
starting at “Select the Program” on page 6 for each program you wish set up at this
time.
To Next Page
Loading...
Need help?
General
