Toro Workman - Using the Rear Cargo Bed Accessory Mount

ClosingtheTailgate
Ifyouunloadedloosematerialsuchassand,
landscapingrock,orwoodchipsfromthecargobedof
themachine,someofthematerialthatyouunloaded
mayhavelodgedinthehingeareaofthetailgate.
Performthefollowingstepsbeforeclosingthetailgate.
1.Useyourhandstoremoveasmuchofthe
materialfromthehingeareaaspossible.
2.Rotatethetailgatetoapproximatelythe45°
position(Figure18).
g034023
Figure18
1.Rotatethetailgateback
andforthseveraltimes.
3.Hingearea
2.Rotatethetailgateto
approximatelythe45°
position.
3.Useashort,shakingmotiontorotatethetailgate
backandforthseveraltimes(Figure18).
Note:Thisactionhelpsmovematerialaway
fromthehingearea.
4.Lowerthetailgateandcheckformaterial
remaininginthehingearea.
5.Repeatsteps1through4untilthematerialis
removedfromthehingearea.
6.Rotatethetailgateupandliftthetailgateintothe
notchesinthecargobed.
UsingtheRearCargoBed
AccessoryMount
Usetherearcargobedaccessorymounttoattach
accessoriestotherearofthemachine.
Capacity:45kg(100lb)
1.Loosenthe“T”handlebyrotatingitclockwise
(Figure19).
g034525
Figure19
1.Receiver
2.“T”handle
2.Insertyouraccessoryintothereceiveruntilthe
holesalign(Figure19).
3.Securetheassembledaccessorytothereceiver
tubeusingtheclevispinandhairpincotter
suppliedwiththeaccessory.
4.Tightenthe“T”handlebyrotatingit
counterclockwise(Figure20).
g034526
Figure20
1.“T”handle
21