15
This message indicates a negative weight, this could happen if you lift or remove the scales plate to correct this put the
plate back in its place and press the key or turn the scale off and then turn it on again.
This message appears when:
If we turn on the scale with a product on the plate, to eliminate this message simply remove the product that is on the scale,
turn off the scale and then turn it on again.
This message indicates that the total was exceeded when the multiplication price per weight exceed 999999 then appear
lines in the "TOTAL" indicator.
If this message appears in intervals on the display, indicates that the scale needs to be recharged. Even with this advise
the scale can continue working during a time of 30 min. If it appears and after some seconds the scale turns off , it indicates
that the scale is completely discharged. In this point the scale doesn't work and all of the operations performed at that time
will be lost. To correct this pr oblem connect the AC/DC adaptor for a period of time of 10 hrs. and keeping the scale off. In
case of using the scale during this period, there's no problem to use it, only the recharge time will be higher.
This arrow indicates that the scale is working under the "FIXED PRICE" mode.
This arrow indicates that the scale AC adaptor is connected to the 120 VCA
To Next Page