5
INTRODUCTION
DEAR CUSTOMER:
We appreciate that you have chosen this product and we assure you that you will get the maximum satisfaction of the new
acquisition for your bussines the scale has been designed to give you a great deal saving time and money, avoiding losses
by human mistakes of interpretation and calculation, offering you more fluency and security in your commercial tasks.
To make your equipment a long lasting investment, we suggest to read carefully this manual and make sure to keep it at
hand for later consultations. In this manual we indicate the necessary steps to benefit and prolong your appliances
availability.
INSTRUCTIONS FOR INSTALLATION
1.- Unpack the scale and check the conditions of the product.
If it is damaged report it inmediately to your authorized distributor.
2.- Place the scale where there is not any movement
or vibration, make sure it is leveled adequately
checking that the four leveling bases are supporting the scale
over the surface were it has been placed and if the level bubble
(under the plate) is centered, to adjust, tighten or loosen the leveling
bases until the bubble is in the center of the circle.
3.- Connect the AC/DC power supply (if you use it)
to a 120 V A.C. outlet.
4.- Turn the scale on after the countdown sequence your
scale will display zeroes and will be ready to use.
IMPORTANT NOTE: If your scale displays "HELP" after you followed the previous steps and after the initial countdown, it
means that it was handled roughly and/or got hit during the shipment, wich cause irreversible damage in its operation. Call
your authorized distributor. It is possible that the scale displays “HELP“ when you turn it on with weight on the plate, when
this happens, remove the weight and turn the scale off and then turn it on
NOTE:ALL THE EXAMPLES IN THIS MANUAL WERE PERFORMED IN A PC-40L SCALE MODEL
To Next Page
Loading...
