Toshiba 40VL20 Series - Page 41

41
Item Description
Status Connected is displayed when
the TV is connected with the AP.
Disconnected is displayed
when the TV is not connected
with the AP.
Signal Connection signal strength with
AP (STRONG/MEDIUM/WEAK)
Speed Link with AP
Mode Working mode (11a, 11b, 11g,
11n)
Network Name SSID set
Authentication Authentication set
Encryption Encryption set
Security Key Security Key set
AP MAC
Address
The AP’s MAC address is
displayed when the TV is
connected with the AP.
TV MAC
Address
The MAC address of the USB
(Dual Band WLAN Adaptor) is
displayed.
DHCP Enabled is displayed when
using DHCP.
Disabled is displayed when not
using DHCP.
IP Address The TV’s IP address
Subnet Mask Value of the Subnet Mask
Default
Gateway
Address of the Default GATEWAY
DNS Address of the DNS
Note:
Even if an AP for IEEE 802.11n is used when
Encryption is set to WEP or TKIP, the Speed value
might below. It is recommended that Encryption be
changed to AES (see “Manual Setup” - page 40).
Notes on wireless LAN environment:
• The function of all IEEE 802.11 is not supported.
• The ad-hoc mode is not supported.
• It is recommended to use IEEE 802.11a or
IEEE 802.11n on 5 GHz for audio and SD video
streaming.
• It is recommended to use IEEE 802.11n on 5 GHz
for HD video streaming.
• It is recommended that the encoding rate for
streaming video content is 20 Mbps or less.
• It is not recommended to use 2.4 GHz for audio
and video streaming.
• Content playback may be interrupted by various
surrounding interference.
Advanced Network Setup
Notes:
• When the DHCP function of the router connected
with this TV is On, you can set Auto Setup to On or
O . (This should usually be set to On.)
• When the DHCP function of the router is O , set
Auto Setup to O , and set the IP Address manually.
IP Address Setup
Auto Setup:
1 From the PREFERENCES menu, select Network
Setup and press Q.
2 Press V or U to select Advanced Network
Setup, and press Q.
3 Press V or U to select IP Address Setup, and
press Q.
4 Select Auto Setup, and then press Y or Z to
select On.
Auto Setup On
Subnet Mask
IP Address Setup
IP Address
Default Gateway
Note:
Other items will be greyed out when Auto Setup is set
to On.
Manual Setup:
1 From the PREFERENCES menu, select Network
Setup and press Q.
2 Press V or U to select Advanced Network
Setup, and press Q.
3 Press V or U to select IP Address Setup, and
press Q.
4 Select Auto Setup, and then press Y or Z to
select O .
5 Press V or U to select IP Address.
6 Press Y or Z to select the  eld you want to
change, and then use the Number buttons to
input the IP address. To save the setting, press
Q.
Connecting your TV
4046VL20Series1En.indd41 2012/02/2814:44:59