430 Series
Installing an Optional Memory Module
To install an optional memory module, make sure the computer is in boot mode then follow
the steps below and refer to Figures 4-8 back to 4-6.
1. Position the connector on the bottom of the module over the corresponding
connector on the computer (align the holes on the side of the module over the
screw holes on the brace).
NOTE: Do not touch the connectors on the memory module or on the
computer. Debris on the connectors may cause memory access problems.
2. Place your fingers above the connector and press firmly but gently to assure a
solid connection. The module should be seated level.
3. Secure the module to the brace with two M2x4 screws.
Figure 4-8 Installing the memory module
4. If the memory module has a plastic tab, fold it down first then lay the cover in
place.
5. Secure it with two silver M2x4 screws.
6. Install the battery pack and optional PC card as described in Sections 4.3 and 4.2.
NOTE: There are two holes for the screw securing the memory module on
one side. When the module is installed, use the inside hole to secure the
module. Otherwise, secure the screw to the outside hole.
Figure 4-9 Securing the screw
To Next Page
Loading...
