430 Series 4-47
4.19 Liquid Crystal Display (LCD) Module (TFT)
Removing the LCD Module (TFT)
To remove the LCD module, follow the steps below and refer to Figures 4-45 and 4-46.
1. Turn off the power to the computer. Disconnect the AC power cord and all
external cables connected to the computer.
2. Remove the battery pack, optional memory module, optional PC card, display
mask and FL inverter board as described in Sections 4.2,4.3, 4.4, 4.16, and 4.17.
NOTE: Support the back of the display with your hand when you remove the
screws.
3. Remove four M2.5x6 screws securing the LCD module to the LCD cover. The
screw at the lower left corner also secures the ground cable.
Figure 4-45 Removing the LCD module screws (TFT)
NOTE: Metal edges on the LCD module are sharp, so be careful not to cut
yourself.
4. Carefully rotate the LCD module out of the LCD cover and lay it on the
keyboard.
To Next Page
Loading...
