430 Series
5. Disconnect the flexible cable from the LCD module and disconnect four display
cables from PJ2, PJ3, PJ4, and PJ5 on the flexible cable.
6. Remove the shielded tape securing the display cables to the LCD cover.
Figure 4-46 Removing the LCD module (TFT)
Installing the LCD Module (TFT)
To install the LCD module, follow the steps below and refer to Figures 4-46 and 4-45.
1. Secure the display cable to the LCD cover with shielded tape.
2. Connect the display cables to PJ2, PJ3, PJ4, and PJ5 on the flexible cable and
connect the flexible cable to the LCD module.
3. Carefully rotate the LCD module into the LCD cover. Be sure the flexible cable
fits securely into the clear plastic protector.
NOTE: Support the back of the display with your hand when you secure the
screws.
4. Secure four M2.5x6 screws with ground cable on the LCD module. Make sure
the ground cable is secured at the lower left corner.
5. Install the FL inverter board, display mask, optional memory module, optional PC card,
and battery pack as described in Sections 4.17, 4.16, 4.4, 4.3, and 4.2.
To Next Page
Loading...
