430 Series
6. Remove one M2.5x4 screw securing the speaker and its brace.
Figure 4-35 Removing the speaker
Installing the Speaker
To install the speaker, follow the steps below and refer to Figures 4-35 and 4-34.
1. Seat the speaker in the speaker brace and secure it with one M2.5x4 screw.
2. Seat the speaker assembly and secure it to the computer with one M2.5x6
screw.
3. Seat the power supply cover. Make sure it fits under the speaker assembly and
that one pin fits through the corresponding hole in the cover.
4. Secure the power supply cover with one M2.5x6 screw.
5. Connect the CD-ROM sound cable to PJ19 on the system board. Secure it with
tape at its original position.
6. Install the sound board, top cover with display assembly, RTC battery, VGA
board, sub-battery, keyboard, HDD, FDD or CD-ROM drive, optional memory
module, optional PC card, and battery pack as described in Sections 4.11 back
through 4.2.
To Next Page
Loading...
