430 Series
4.16 Display Mask
Removing the Display Mask
To remove the display mask, follow the steps below and refer to Figures 4-41 and 4-42.
1. Turn off the power to the computer. Disconnect the AC power cord and all
external cables connected to the computer.
2. Remove the battery pack, optional PC card and optional memory module as
described in Sections 4.2, 4.3, and 4.4.
NOTE: It is not necessary to remove the top cover with display assembly.
3. Remove two seals from the display hinges and two rubber cushions from the top
corners to expose screws securing the display mask.
NOTE: Support the back of the display with your hand when you remove the
screws.
4. Remove four M2.5x6 screws that were covered by the seals and cushions.
Figure 4-41 Removing the seals, cushions and screws
To Next Page
Loading...
