430 Series
Installing the Keyboard
To install the keyboard, follow the steps below and refer to Figures 4-21 back to 4-18.
1. Connect the keyboard cable to PJ13 on the system board. Make sure the cable
connection is secure.
2. Fit the two tabs of the metal cover into the top cover and backup battery base (see
Figure 4-21), then seat the metal cover and secure it with three M2.5x6 screws.
Make sure the plastic tab on the LED connector is under the metal cover.
NOTE: If the unit under repair has a keyboard connector cover that slides
along the keyboard cable, then first thread the keyboard cable through the
hole in the keyboard connector cover. The metal cover for this kind of
connector has four M2.5x6 screws.
Figure 4-21 Seating the metal cover
3. Fit the keyboard connector cover on the metal cover and secure it with two
M2.5x6 screws (or one M2.5x6 screw w/washer if the unit has a sliding
connector cover).
4. Replace the tape.
5. Fit tabs on the back of the keyboard into corresponding holes on the computer and
lay the keyboard in place.
6. Secure six latches on the back of the keyboard base, two latches at the ends, and
six latches along the front.
7. Install the HDD, FDD or CD-ROM drive, optional memory module, optional PC
card, and battery pack as described in Sections 4.7 back through 4.2.
To Next Page
Loading...
