430 Series
6. Remove four flat-head M3x4 screws securing the frame to the HDD and
separate the HDD from the frame.
Figure 4-17 Removing the HDD from the frame
Installing the HDD Drive
To install the HDD drive, follow the steps below and refer to Figures 4-17 and 4-16.
1. Secure the frame to the HDD with four flat-head M3x4 screws.
2. Attach the HDD frame brace to the HDD frame.
3. Seat the HDD in the computer and press to secure the connection.
4. Secure the HDD frame to the computer with two M2.5x6 screws.
5. Install the FDD or CD-ROM drive, optional memory module, optional PC card,
and battery pack as described in Sections 4.6 back through 4.2.
To Next Page
Loading...
