430 Series
Installing the Infrared Board
To install the infrared board, follow the steps below and refer to Figure 4-38.
1. Replace the tape and connect the infrared board cable (inner harness) to PJ17 on
the system board.
2. Connect the infrared board cable to PJ101.
3. Slide the infrared board into its notch on the computer to seat it.
4. Secure the board with one M2.5x4 screw.
5. Install the AC PS unit, speaker, sound board, top cover with display assembly,
RTC battery, sub-battery, VGA board, keyboard, HDD, FDD or CD-ROM drive,
optional memory module, optional PC card, and battery pack as described in
Sections 4.13 back through 4.2.
To Next Page
Loading...
