430 Series
Installing the FL Inverter Board (TFT)
To install the FL inverter board, follow the steps below and refer to Figure 4-43.
1. Connect the FL inverter cable to CN1 and the FL cable to CN2 on the FL
inverter board.
2. Replace the tape.
3. Seat the FL inverter board.
NOTE: Be sure to support the back of the display with your hand.
4. Secure the FL inverter board with two M2.5x6 screws. Be sure that the left
screw secures the ground cable.
5. Install the display mask, optional memory card, optional PC card, and battery
pack as described in Sections 4.16, 4.4, 4.3, and 4.2.
To Next Page
Loading...
