430 Series
This subtest prints the various print types shown below:
Subtest 03 Wraparound
NOTE: To execute this subtest, a printer wraparound connector must be
connected to the printer port. The printer wraparound connector
(34M741986G01) wiring diagram is described in Appendix F.
This subtest checks the output and bidirectional modes of the data control and
status lines through the printer wraparound connector.
PRINTER TEST
1. THIS LINE SHOWS NORMAL PRINT.
2. THIS LINE SHOWS DOUBLE-WIDTH PRINT.
3. THIS LINE SHOWS COMPRESSED PRINT.
4. THIS LINE SHOWS EMPHASIZED PRINT.
5. THIS LINE SHOWS DOUBLE-STRIKE PRINT.
6. ALL CHARACTERS PRINT
!”#$%&’()*+,./
0123456789:;<=>?@ABCDEFGHIJKLMNOPQRSTUVWXYZ[\]^_‘abcdefghijklmn
opqrstuvwxyz{|}~
To Next Page
Loading...
