Toshiba BMS-CT1280TU - Set the Operation Schedule

43
Confirming Digital Output Signals
1 Tap [1-(1)] in Digital Output.
To confirm digital output signals, set the interface that you want to
confirm in the same was as in steps 2 and 3 in "Confirming Digital
Input Signals".
To confirm the signal is being output, tap the channel to confirm.
• If the channel is red, the output is controlled.
• If the channel is grey, the output is not controlled.
2 Tap [2-(1)].
Output control is executed.
Exiting Digital IO Confirmation
1 Do operation to move to another screen
"The digital output status of normal control is valid. Is it OK?" is
displayed.
2 Tap [2-(1)].
1
-(1)
1
-(1)
2
-(1)
2
-(1)
2
-(1)
2
-(1)