2 Precautions for the handling of Wireless Communication Devices
Precautions for the handling of Wireless Communication Devices
This product is classified as “wireless equipment for stations of low-power data transmissions systems” under the
Wireless Telegraphy Act, and does not require a radio transmission license. The law prohibits modification of the
interior of this product.
Regulatory Information
This product must be installed and used in strict accordance with the manufacturer’s instructions as described in the
user documentation that comes with the product. This product complies with the following radio frequency and
safety standards.
Standards below are certified under the operation with the provided antenna. Do not use this product with other
antennas.
USA-Federal Communications Commission (FCC)
NOTE:
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operations of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense.
CAUTION:
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the grantee of this device could void the user’s authority to
operate the equipment.
RF EXPOSURE WARNING:
This equipment must be installed and operated in accordance with provided instructions and the antenna(s) used for
this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be
co-located or operating in conjunction with any other antenna or transmitter. End-users and installers must be
provide with antenna installation instructions and transmitter operating conditions for satisfying RF exposure
compliance.
Approved Countries/Regions for Use for the Devices
This equipment is approved to the radio standard by the specific countries/regions. Please ask Toshiba Tec
authorized dealers or service technicians.
Precaution for Use
This product communicates with other devices by radio. Depending on the installation location, orientation,
environment, etc., its communication performance may deteriorate or devices installed near by may be affected.
Bluetooth
®
and Wireless LAN devices operate within the same radio frequency range and may interfere with one
another. If you use Bluetooth
®
and Wireless LAN devices simultaneously, you may occasionally experience a less than
optimal network performance or even lose your network connection.
If you should experience any such problem, immediately turn off your Bluetooth
®
or Wireless LAN device.
Keep away from a microwave.
Communication performance may deteriorate or a communication error may occur due to the radio emitted from a
microwave.
Do not use the product on a metal table or near a metal object. Communication performance may be deteriorated.
* Bluetooth
®
is a registered trademark owned by Bluetooth SIG, Inc.
To Next Page
Loading...
