What to do if Toshiba Controller is in RUN execution with tracking cable broken?
To start the controller in RUN mode when the tracking cable is broken, carry out an error reset operation to set the operation mode to HALT. At this time, make sure that the mode switch is set to "RUN".
What to do if all intelligent I/O channels failed on Toshiba Controller?
If all intelligent I/O channels have failed, check the serial bus cable connections.
What to do if disconnected duplex tracking cable is detected in Toshiba C3PU35?
If a disconnected duplex tracking cable is detected (this problem can occur on the controller in duplex configuration), replace the duplex tracking cable and boot the standby L3 CPU module.
General| Chipset | Unknown |
|---|---|
| Memory Capacity | Unknown |
| Operating Temperature | Unknown |
| Dimensions | Unknown |
| Weight | Unknown |
| Communication Port | USB |
To Next Page
