e-STUDIO167/207/237 © 2007 - 2008 TOSHIBA TEC CORPORATION All rights reserved
SCANNER
6 - 26
[I] CIS unit drive belt-1
(3) Take off the CIS case.
Fig. 6-35
Notes:
1. When installing the CIS case, be sure to
fit the shaft of the equipment in the shaft
guide attached on the bottom of the CIS
case.
2. When installing the CIS case, install it so
that the “L” shaped portion of the bottom
of the CIS case comes under the CIS unit
drive belt-1.
Fig. 6-36
(1) Take off the CIS case.
P.6-25 "[H] CIS case"
(2) Loosen 1 fixing screw of the tension bracket.
Fig. 6-37
CIS case
Shaft
Shaft guide
L shaped potion
Tension bracket
To Next Page
Loading...
