2
© 2007 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO167/207/237
OUTLINE OF THE MACHINE
2 - 27
(4) Disconnect 7 connectors.
(5) Remove 1 screw and 1 ground wire.
Note:
Make sure that the position is correct when
inserting the connector.
Fig. 2-33
Fig. 2-34
(6) Remove 8 screws, release 1 locking support,
and take off the switching regulator board.
Fig. 2-35
Connector Connector
1
2
3
4
White Gray
Black Brown
Green/Yellow
Black
White
Switching regulator board
Locking support
To Next Page
Loading...
