1
© 2007 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO167/207/237
SPECIFICATIONS / ACCESSORIES / OPTIONS / SUPPLIES
1 - 3
Paper feeding ......................... Standard drawer:
1 drawer (stack height 28 mm, equivalent to 250 sheets; 64 to 80 g/m
2
(17 to 22 lb. Bond))
Bypass feeding:
Stack height 11.8 mm: equivalent to 100 sheets; 64 to 80 g/m
2
(17 to
22 lb. Bond)
Paper Feed Unit (PFU):
Option (One drawer: stack height 28 mm, equivalent to 250 sheets; 64
to 80 g/m
2
(17 to 22 lb. Bond))
Paper Feed Pedestal (PFP):
Option (One drawer or two: stack height 60.5 mm, equivalent to 550
sheets; 64 to 80 g/m
2
(17 to 22 lb. Bond))
Capacity of originals in the ADF/RADF (Option)
.................................................. A3 to A5-R, LD to ST-R:
100 sheets / 80 g/m
2
(Stack height 16 mm or less)
Automatic duplexing unit (ADU: Option)
.................................................. Stackless, Switchback type
Toner supply........................... Automatic toner density detection/supply
Toner cartridge replacing method (There is a recovered toner supply
mechanism.)
Density control ..................... Automatic density mode and manual density mode selectable in 7
steps
Weight.................................. Approximately 32.5 kg (71.65 lb.) (excluding the developer material
and toner)
Power requirements...AC 110 V / 13.2 A, 115 V or 127 V / 12 A
220-240 V or 240 V / 8 A (50/60 Hz)
* The acceptable value of each voltage is ±10%.
Power consumption ...1.5 kW or less (100 V series)
1.6 kW or less (200 V series)
* The electric power is supplied to the ADF/RADF, PFU, PFP and ADU through the equipment.
Total counter ..............Electronical counter
To Next Page
Loading...
