e-STUDIO167/207/237 © 2007 - 2008 TOSHIBA TEC CORPORATION All rights reserved
PAPER FEEDING SYSTEM
10 - 22
[N] Pickup solenoid (SOL1)
(3) Release the harness from the harness
clamp, disconnect 1 connector and take off
the registration roller clutch.
Fig. 10-38
(1) Take off the rear cover.
P.2-22 "[J] Rear cover"
(2) Release the harness from the harness clamp
and disconnect 1 connector.
Fig. 10-39
(3) Remove 1 screw and take off the pickup
solenoid bracket.
Note:
Be sure not to drop the bushing.
Fig. 10-40
Registration roller clutch
Connector
Harness clamp
Connector
Pickup solenoid bracket
Screw
Bushing
To Next Page
Loading...
