e-STUDIO167/207/237 © 2007 - 2008 TOSHIBA TEC CORPORATION All rights reserved
PAPER FEEDING SYSTEM
10 - 24
[P] Registration roller (rubber)
Note:
When assembling the drawer pickup clutch,
adjust the position of the hook of the spring
and the covers so that the stopper of the
cover-B and the center of the rib of the
cover-A are aligned.
Fig. 10-44
(1) Take off the transfer/separation charger.
P.11-16 "[L] Transfer/Separation charger"
(2) Remove 1 clip and take off 1 gear and the
registration roller (rubber) while sliding them
to the front side.
Fig. 10-45
(3) Remove 2 washers, 1 E-ring, 1 gear, and 1
pin from the registration roller.
Fig. 10-46
Rib
Slit
Stopper
Cover-A
Cover-B
Registration roller (rubber)
Clip
Registration roller (rubber)
Pin
E-ring
Gear
Washer
Washer
To Next Page
Loading...
