24 Network Administrator’s Guide — Setup Flow for Printing Features
installations for users.) For more information about the SMB installation, please see the
Printing Guide.
In the SMB enabled network, users must install following client software for printing:
• Printer Drivers
• TopAccessDocMon
• Agfa Font Manager
Setup Flow for Peer-to-Peer Printing
This equipment provides the Peer-to-Peer Utility, (for Windows 98 and Windows Me), that
enables a peer-to-peer connection over the TCP/IP network. The Peer-to-Peer Utility allows
users to add the Peer-to-Peer TCP/IP port by searching for the equipment in the local area net-
work. If an administrator does not allow printer sharing in a Windows network, (which means
the SMB print service is disabled), he or she can permit users to connect to this equipment using
the Peer-to-Peer Utility.
NOTE:
• TopAccessDocMon cannot be used when you configure the printer connection
using the Peer-to-Peer utility.
Setup procedure
Step 1: Setting up the TCP/IP and the HTTP Network Service to enable TopAc-
cess.
You should set the TCP/IP and HTTP Network Service from the Touch Panel Display the
first time you use it, to make TopAccess available. Please see the User Functions Guide to
configure the TCP/IP and HTTP Network Service from the Touch Panel Display, or from
TopAccess.
P.53 "Setting up the TCP/IP"
P.58 "Setting up the HTTP Network Service"
Step 2: Advise users to install the Client Software for Peer-to-Peer printing.
Users can get the printer drivers for Peer-to-Peer printing by installation from the Client1
CD-ROM. For more information about the Peer-to-Peer installation, please see the Printing
Guide.
In the Peer-to-Peer enabled network, users must install following client software for print-
ing:
Windows 98
Windows Me
Windows 98
Windows Me
Windows 98
Windows Me
Connecting over TCP/IP Network
Setting up the TCP/IP
printer connection with
Peer-to-Peer Utility
To Next Page
Loading...
