74 Network Administrator’s Guide — Setting up Save as file Settings
Setting up Save as file Settings
In the Save as file submenu page in the Setup menu, an administrator can configure the Send to
File settings that apply to the Save as file operations. An administrator also configures the Send
to File settings that apply to the Save as file operation using the N/W-Fax driver.
NOTE:
• Some settings may not apply to the Touch Panel Display as soon as you save the
settings. When you change the settings, press the [RESET] button on the Control
Panel before an operation.
Setting the Save as file settings
1. Access TopAccess in the administrator mode.
P.15 "Accessing TopAccess Administrator Mode"
2. Click the Setup menu and Save as file submenu.
• The Save as file submenu page is displayed.
3. In the Save as file submenu page, set the Send to File set-
tings as required.
• In the Save as file submenu page, you can set the following:
P.75 "Setting up the Local Storage Path"
P.75 "Setting up the Storage Maintenance"
P.76 "Setting up the Destination"
P.76 "Setting up the Remote 1 and Remote 2"
For e-STUDIO450 Series and e-STUDIO280 Series:
The Save as file submenu page in the Setup menu is available only when the Printer Kit and
Scanner Upgrade Kit are installed, or when the Printer/Scanner Kit is installed.
To Next Page
Loading...
