24
1.BEFORE USING EQUIPMENT
1.Description of Each Component (Cont.)
1
9. Finisher (Type A) (MJ-1023)
This finisher enables sort/group finishing and stapling. (The Hole Punch Unit sold separately can be
installed to this finisher.) The Bridge Unit (KN-3520 sold separately) is required when installing this fin-
isher.
10. Hanging Finisher (MJ-1022) (for e-STUDIO352 only)
This finisher enables sort/group finishing and stapling. The Bridge Unit (KN-3520 sold separately) is
required when installing this finisher.
11. Finisher (Type B) (MJ-1101)
This finisher enables sort/group finishing and stapling (including manual stapling). (The Hole Punch
Unit sold separately can be installed to this finisher.) The Bridge Unit (KN-3520 sold separately) is
required when installing this finisher.
12. Hole Punch Unit (MJ-6004)
This unit enables you to punch holes on printouts. It can be installed to the Saddle Stitch Finisher
(MJ-1024) and Finisher (Type A) (MJ-1023).
13. Hole Punch Unit (MJ-6101)
This unit enables you to punch holes on printouts. It can be installed to the Finisher (Type B)
(MJ-1101).
Other options available are as follows. Contact your service technician or Toshiba product distributors for
details. (Options may vary depending on destination.)
Work Table (KK-3511)
FAX Unit (GD-1200)
2nd Line for Fax Unit (GD-1160)
Desk (MH-1700)
Data Overwrite Kit (GP-1060)
Scrambler Board (GP-1040)
Wireless LAN Module (GN-1041)
Bluetooth Module (GN-2010)
Antenna (GN-3010)
Printer Kit (GM-1060)
Printer/Scanner Kit (GM-2060)
Scanner Kit (GM-4060)
PCI Slot (GO-1060)
To Next Page
Loading...
