Toshiba e-STUDIO 452 - Ready (Check Saddle Stitch Stapler)

312
10.WHEN THIS MESSAGE APPEARS
10
6. “READY (CHECK SADDLE STITCH STAPLER)”
This message will be shown only when the Saddle Stitch Finisher (optional: MJ-1024) is installed. It
appears when the staples in the stapler of the Saddle Stitch Finisher run out or when the staples in the
Saddle Stitch Finisher are jammed.
Remove the jammed staples according to the procedure in  P.309 “5.“Examine stapler in the Saddle
Stitch Unit””.
If the staples run out, follow the procedure below as well as the procedure in  P.300 “2.“Check staple
cartridge in the Saddle Stitch Unit””.
1
Follow steps 1 to 6 of  P.300 “2.“Check staple cartridge in the Sad-
dle Stitch Unit””.
• Do not close the front cover of the Saddle Stitch Finisher.
2
Check the following 2 items to perform test stapling.
• Whether the Saddle Stitch Finisher is securely installed in the equipment.
• Whether any A3, A4-R or B4 paper is set in the equipment.
3
Close the front cover of the Saddle Stitch Finisher.
• Test stapling is automatically performed.
If the front cover of the Saddle Stitch Finisher is closed without satisfying the condition of step 2, test stapling is
not performed. Test stapling is necessary to prevent void stapling. After satisfying the condition of step 2 and
opening/closing the front cover of the Saddle Stitch Finisher again, be sure to perform the test stapling.