81
2
6
Change the settings as required.
• The setting of the number of the copy sets, page number, time stamp, sort/stapling (when the optional Finisher
has been installed) and hole punch (when the optional Hole Punch Unit has been installed) can be changed.
• If you want to change the setting of the copy density, original mode, zoom or simplex/duplex, press the [MEM-
ORY CLEAR] button to clear the proof copy. After the change, perform the instructions from step 1 again.
7
Press the [START] button.
• If the number of copy sets is not changed in step 6, one less than the previously specified number is copied.
However, if "1" is specified for the number of copy sets, one set of copies is made.
To Next Page
Loading...
