1.TROUBLESHOOTING FOR THE HARDWARE
Clearing a Paper Jam 27
1 TROUBLESHOOTING FOR THE HARDWARE
5
If the paper size is small, turn the knob shown in the following figures to send the
paper, and then remove the jammed paper.
When the Hole Punch Unit is installed, open the front cover of the finisher and turn the 2 knobs at the same
time.
4
Remove the jammed paper from the right or left side.
6
Remove the paper jammed in the equipment side.
7
Lower the shutter of the paper exit portion and
remove the paper.
When the Hole Punch Unit is not installed
When the Hole Punch Unit is installed
2
1
To Next Page
Loading...
