Toshiba E-Studio 5540c - Paper Jam in the Finisher and the Hole Punch Unit (both Optional)

1 TROUBLESHOOTING FOR THE HARDWARE
26 Clearing a Paper Jam
 Paper jam in the Finisher and the Hole Punch Unit (both optional)
1
Separate the Finisher from the equipment.
1) Open the front cover of the finisher when the Hole Punch Unit is not installed. Open the Hole Punch Unit cover
when the Hole Punch Unit is installed.
2) Pull the lever to unlock the finisher.
3) Placing your hands on the positions shown in the figure, move the finisher slowly until it stops, and then open
the front cover of the finisher.
2
Raise the lever and open the upper receiving tray of
the finisher.
3
Remove the jammed paper.
2
2
1
1
When the Hole Punch Unit is not installed
When the Hole Punch Unit is installed
When the Hole Punch Unit is not installed
When the Hole Punch Unit is installed