Toshiba E-Studio 5540c - Refilling the Saddle Stitch Unit Staples

1 TROUBLESHOOTING FOR THE HARDWARE
58 Refilling With Staples
6
Close the front cover of the finisher.
If the message “Check staple cartridge” remains, repeat the procedure above from steps 1 to 6.
 Refilling the Saddle Stitch unit staples
When the staples of the stapler in the Saddle Stitch Finisher MJ-1104 have run out, refill the staples following the
procedure below.
5
Fit the staple cartridge into the stapler.
When fitting the staple cartridge, hold the green-labeled portion of the
bracket securely so that it will not move.
Insert the cartridge until it is caught by the latch and fixed with a click.
1
Open the front cover of the finisher, and pull out the
Saddle Stitch unit until it stops.
2
Remove the staple cartridges.
Replace both cartridges at a time.
3
Press the buttons on both sides of the cartridge.
The transparent cover of the cartridge is lifted.
2
1
2
1