e-STUDIO205L/255/305/355/455 © 2009 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND TROUBLESHOOTING
6 - 98
[CDE0] Paddle motor abnormality
1. Replace the staple/fold motor (M7).
2. Replace the finisher controller PC board.
MJ-1025
Is the paddle home position sensor (PI2) working properly?
NO Replace the sensor.
YES
Is the Swing guide home position sensor (PI3) working properly?
NO Replace the sensor.
YES
Is the wiring between the finisher controller PC board and Paddle motor (M2) correct?
NO Correct the wiring.
YES
Try to rotate the paddle motor (M2) clockwise and counterclockwise by hand. Is there
mechanical trapping in the rotation of the paddle or the up/down movement of the swing
guide?
YES Fix the mechanism.
NO
1. Replace the paddle motor (M2)
2. Replace the finisher controller PC board.
* You receive a [CDE0] error when the [ED15] error occurs three times in succession or during
the initial operation.
MJ-1101
Is there any mechanical problem with the paddle is rotated?
YES Fix the mechanism.
NO
Is the harness between the paddle motor (M8) and the finisher control PC board (CN6)
disconnected or open circuited?
l
YES • Reconnect the connector securely.
• Replace the harness.
NO
1. Replace the paddle motor (M8).
2. Replace the finisher control PC board.
To Next Page
Loading...
