6
© 2009 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO205L/255/305/355/455
ERROR CODE AND TROUBLESHOOTING
6 - 99
[CE00] Communication error between finisher and puncher unit
MJ-1025 (when MJ-6005 is installed)
Is the problem solved by turning the power of the equipment OFF and ON?
YES End.
NO
Is the wiring between the finisher controller PC board and the punch controller PC board
correct?
NO Correct the wiring.
YES
Measure the voltage between CN14-5 (+) and CN14-3 (-) on the finisher controller PC
board 24 V?
NO Replace the finisher controller PC board.
YES
Replace the punch controller PC board.
MJ-1024 (When MJ-6004 is installed)
Is the problem solved by turning OFF and ON the power of the equipment?
YES End.
NO
Is the wiring between the finisher controller PC board and punch controller PC board correct?
NO Correct the wiring.
YES
1. Replace the finisher controller PC board.
2. Replace the punch controller PC board.
MJ-1101 (When MJ-6101 is installed)
Is the harness between the hole punch control PC board (HP) and the finisher control PC
board disconnected or open circuited?
YES Replace the harness. Correct the wiring.
NO
Is the conductor pattern on the hole punch control PC board (HP) open circuited or short
circuited?
YES Replace the hole punch control PC board (HP).
NO
Replace the finisher control PC board.
To Next Page
Loading...
