e-STUDIO205L/255/305/355/455 © 2009 TOSHIBA TEC CORPORATION All rights reserved
FIRMWARE UPDATING
8 - 8
Fig. 8-3
Notes:
• The display of items on this screen varies depending on the types of data written on the USB
media. Each item is displayed only when each data file is written on the USB media in the
following conditions.
• For "2. HDD SYS Update", "3. Engine Main Firmware Update" and "4. Scanner Firmware
Update", an asterisk (*) indicating that the item to be installed is not displayed next to one
already installed in the same version as that of the update data for the purpose of efficiency,
and this will not happen in the standard setting. If you want to install it, select it manually
before starting the update.
• If the USB media are not recognized properly, “Set Correct USB Storage Device” message is
displayed. In this case, disconnect the USB media and connect again within 3 minutes, or
shut down the equipment and connect the device properly. Then repeat the procedure from
(4).
• If any of the error messages below is displayed, confirm if the update program or the data file
in the USB media is correct. Then repeat the procedure from (4).
Item Condition
1. OS Update firmImage0.bin is written.
2. HDD SYS Update hdd.bin is written.
3. Engine Main Firmware Update T470MWW.xxx is written.
* xxx is version.
4. Scanner Firmware Update T471SLGWW.xxx is written.
* xxx is version.
Error
number
Error message Cause
- There is no mentusb2.o Update program loader (mentusb2.o)
is not stored.
01 There is no dlFirmWare_205_455 in the storage
device.
Model specific update program
(dlFirmWare_205_455 ) is not stored.
01 There is no dlFirmWare_xxx_xxx in the storage
device.
* The model name comes at “xxx_xxx”.
The jumper line on the SYS board is
set for another model.
02 Error Loadmodule Module loading failed.
03 Machine Model Get Error Model information was not
downloaded.
04 Please Change USB Storage or Please Check
ROMDATA
Checking of data file failed.
05 Other models ROMDATA Vxxxx.xxx x
* The version name comes at “xxxx.xxx.x”.
Master data of other model (hdd.bin)
are stored.
To Next Page
Loading...
