Toshiba e-STUDIO350 - Page 100

e-STUDIO350/450 CONTROL PANEL 5 - 6 November 2003 © TOSHIBA TEC
5
Displayed when reproduction ratio is set to
be over 200% at AMS Mode on RADF
Displayed when reproduction ratio is set
manually to be over 200% on RADF
Displayed when the template stored is
recalled by pressing [TEMPLATE] button
Displayed when a button is pressed while the
department management setting is available
Displayed when the number of printouts
exceeds the limit number of department
counter
Displayed when confirming the user to print
out the data as much as stored at memory
- full state
Displayed when confirming the user to send
the FAX data as much as stored at memory
- full state
Displayed when confirming the user to save
the scanning data as much as stored at
memory-full state
Displayed when confirming the user to print
out the data as much as stored at memory-
full state
Displayed when confirming the user to send
the FAX data as much as stored at memory-
full state
Displayed when confirming the user to save
the scanning data as much as stored at
memory-full state
No toner in the cartridge
PM cycle
- Displayed at the time for maintenance
- Copying is available
Displays when the printing is stopped
because of media type mismatch
Dsiplays the warning that the copy is not
enabled when any drawer but bypass feed is
selected at Cover Sheet Mode or Sheet
Insertion Mode.
Set the reproduction ratio 200% or
below manually
Set the reproduction ratio 200% or
below
Displayed only in FAX Function
Displayed only in FAX Function
Displayed only in FAX Function
Displayed only in Scanning Function
Displayed when toner is running out.
Copying not enabled
Maintenance and inspection are
performed by qualified service
technician.
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
Cannot use AMS
mode
More than 200% is
not available
Updated the template
setting
Enter Department
Code
Cannot copy Check
DEPARTMENT
COUNTER
Not enough memory
to store original(s)
Will you print out
stored originals?
Not enough memory
to store original(s)
Will you send stored
originals in?
Not enough memory
to store original(s)
Will you save stored
originals in?
The number of
originals exceeds the
limits Will you copy
stored originals?
The number of
originals exceeds the
limits.
Will you send stored
originals?
The number of
originals exceeds the
limits.
Will you save stored
originals?
Install new toner
cartridge
Time for periodic
maintenance
READY
(CHANGE DRAWER
TO CORRECT
MEDIA TYPE)
PRESS [BASIC]
and select normal
paper size
No. Message State of equipment Note