Toshiba e-STUDIO350 - Relation between System Configuration and IH Output

November 2003 © TOSHIBA TEC 13 - 7 e-STUDIO350/450 FUSER UNIT / PAPER EXIT SECTION
13
13.4.4 Relation between system configuration and IH output
* RADF: Reversing Automatic Document Feeder, FIN: Finisher, HPU: Hole Punch Unit,
LCF: Large Capacity Feeder, FAX: FAX unit
(*1) The wattage lowers 50 W more when the scanning is performed from the RADF during warming up.
(*2) AC power should be input voltage when the equipment is warming up (The lower the voltage is,
the longer the warming up time becomes).
System configuration
Equipment only
Equipment and
RADF
(*1)
Equipment, RADF
(*1)
and FIN
Equipment, RADF
(*1)
,
FIN, and HPU
Equipment, RADF
(*1)
,
FIN, HPU and LCF
Equipment, RADF
(*1)
,
FIN, HPU, LCF and
FAX
Warming up
(*2)
1240-1200W
1220-1140W
1160-1080W
Ready
700W
Printing
980W
Energy Saving
Mode
OFF
Automatically
OFF
OFF
Warming
up time
Approx.
20sec.
Approx.
25sec.
Approx.
30sec.