Toshiba e-STUDIO350 - 1 Specifications; Accessories; Options; Supplies; Specifications

November 2003 © TOSHIBA TEC 1 - 1 e-STUDIO350/450 SPECIFICATIONS
1
1. SPECIFICATIONS / ACCESSORIES / OPTIONS / SUPPLIES
1.1 Specifications
Values in [ ] are for e-STUDIO450 in case that the specification is different between e-STUDIO350 and
e-STUDIO450.
• Copy process Indirect electrophotographic process (dry)
• Type Desktop type (console type:when paper feed pedestal (PFP) and large capac-
ity feeder (LCF) are installed)
• Original table Fixed type (the left rear corner used as guide to place originals)
• Accepted originals Sheet, book and 3-dimensional object. The reversing automatic document
feeder (RADF) only accepts paper which are not pasted or stapled. (Single-
sided originals: 50 to 127 g/m
2
/13 to 34lb. Bond, Double-sided originals: 50
to105 g/m
2
/13 to 28 lb. Bond) Carbon paper are not acceptable either.
Maximum size : A3/LD
• Copy speed (Copies/min.)
*
“–” means “Not acceptable”.
*
The copy speed in the above table are available when originals are manually placed for single side,
multiple copying.
*
When the RADF is used, the copy speed of 35[45] sheets per minute is only available under the
following conditions:
• Original/Mode: Single side original/A4/LT size. APS/automatic density are not selected.
• Number of sheets: 35[45] or more.
• Paper feeding: LCF
• Reproduction ratio: 100%
e-STUDIO450
e-STUDIO350
Paper supply
Paper size
A4, LT, B5
A4-R, B5-R,
A5-R, LT-R, ST-R
B4, LG
A3, LD
Drawer
35
25
21
18
Size specified
35
25
21
18
Size not specified
18
18
18
18
PFP
35
25
21
18
Bypass feed
LCF
35
–
–
–
Paper supply
Paper size
A4, LT, B5
A4-R, B5-R,
A5-R, LT-R, ST-R
B4, LG
A3, LD
Drawer
45
28
24
21
Size specified
40
28
24
21
Size not specified
21
21
21
21
PFP
45
28
24
21
Bypass feed
LCF
45
–
–
–