Toshiba e-STUDIO350 - Page 10

e-STUDIO350/450 SPECIFICATIONS 1 - 2 November 2003 © TOSHIBA TEC
1
* System copy speed
• First copy time ................... e-STUDIO350: Approx. 3.9sec. or less
e-STUDIO450: Approx. 3.9sec. or less
(A4/LT, upper drawer, 100%, original placed manually)
• Warming-up time ............... Approx. 20 seconds (temperature: 20°C)
• Multiple copying ................. Up to 999 copies; Key in set numbers
• Reproduction ratio ............. Actual ratio: 100±0.5%
Zooming: 25 to 400% in increments of 1%
(25 to 200% when using RADF)
• Resolution/Gradation ......... Scanning: 600 dpi x 600 dpi
........ Printing: Equivalent to 2400 dpi x 600 dpi
........ Gradation: 256 steps
*
The system copy speed, including
scanning time, is available when 10
sheets of A4/LT size original are
set on RADF and one of the copy
modes in the left table is selected.
The period of time from pressing
[START] to the paper exit com-
pletely out of the equipment based
on the actually measured value.
*
Upper drawer is selected and
copying is at the non-sort mode.
*
Automatic copy density, APS/AMS
are turned off.
*
Finisher is not installed.
• Copy paper
Drawer ADU PFP LCF Bypass copy Remarks
Size A3 to A5-R A3 to A5-R,LD to ST-R
LD to ST-R A4, LT (Non-standard or user-
specified sizes can be set.)
Weight 64 to 209 g/m
2
,17 to 55 lb.
64 to 105 g/m
2
(Continuous feeding)
17 to 28 lb. 50 to 209 g/m
2
, 13 to 55 lb.
(Single pape r feeding)
Special Tracing paper, labels,
paper – OHP film (thickness: 80 µm
or thicker)
These special papers
recommended
by Toshiba Tec
Single-sided originals
↓
Single-sided copies
Single-sided originals
↓
Double-sided copies
Double-sided originals
↓
Double-sided copies
Double-sided originals
↓
Single-sided copies
e-STUDIO350
20.85
57.95
91.20
27.42
62.18
97.55
55.47
126.21
196.93
48.22
117.44
184.96
Copy mode
1 set
3 sets
5 sets
1 set
3 sets
5 sets
1 set
3 sets
5 sets
1 set
3 sets
5 sets
e-STUDIO450
17.49
46.68
73.50
25.71
57.41
89.03
54.68
118.07
181.36
48.20
102.18
155.06
Sec.