e-STUDIO350/450 SCANNER 6 - 22 November 2003 © TOSHIBA TEC
6
Fig. 6-722
Fig. 6-723
[L] Platen sensor / Carriage home position
sensor
(1) Take off the rear cover and upper rear cover
( Chapter 2.5.1 [C][G]).
(2) Disconnect 1 connector from the platen sen-
sor on the left rear position of the equipment
upper side.
(3) Release the latches of the sensor from the
frame and take off the platen sensor.
(4) Disconnect 1 connector from the carriage
home position sensor on the left rear position
of the equipment upper side.
(5) Release the latches of the sensor from the
frame and take off the carriage home position
sensor.
[M] SLG board
(1) Take off the lens cover ( Chapter 6.7 [B]).
(2) Disconnect 8 connectors from the SLG board.
(3) Remove 6 screws and take off the SLG board.
Carriage home
position sensor
Platen sensor
To Next Page
Loading...
