November 2003 © TOSHIBA TEC 9 - 11 e-STUDIO350/450 PAPER FEEDING SYSTEM
9
(7) Open the side cover.
(8) Remove 2 screws, lift the bypass unit up, re-
move 2 hooks and pull it out to the front.
(A-2) Hinge assembly
(1)
Take off the bypass unit ( Chapter 9.4 (A-1)).
(2) Disconnect 1 connector and release the har-
ness from harness clamp.
(3) Remove 2 screws and slide the hinge assem-
bly to take it off with the tray. (Standing the
tray makes easier to be removed.)
Fig. 9-405
Fig. 9-406
Fig. 9-407
Fig. 9-408
Side cover
Screw
Screw
Bypass unit
Screw
To Next Page
Loading...
