November 2003 © TOSHIBA TEC 10 - 5 e-STUDIO350/450 DRIVE SYSTEM
10
(6) Disconnect 2 connectors.
(7) Remove 5 screws and take off the gear unit.
Fig. 10-405
Connector
Fig. 10-406
Screw
Screw
Gear unit
Fig. 10-407
[D] Developer drive clutch
(1) Take off the gear unit ( Chapter 10.4 [C]).
(2) Remove 2 screws and take off the bracket.
(3) Remove the bushing and take off the devel-
oper drive clutch.
Note:
Match the protruding portion of clutch with
the position shown in the drawing for as
sembling.
Bracket
Screw
Bushing
Developer drive
clutch
To Next Page
Loading...
