Toshiba e-STUDIO350 - Page 249

November 2003 © TOSHIBA TEC 13 - 25 e-STUDIO350/450 FUSER UNIT / PAPER EXIT SECTION
13
Fig. 13-737
[P] Exit roller
(1) Take off the fuser unit ( Chapter 13.7 [A]).
(2) Open the fuser unit cover and transport guide.
(3) Remove 1 spring. Then remove E-ring (small),
gear unit and gear in order.
(4) Release the spring force (2 springs) of the
lower exit roller.
(5) Remove E-rings and bushings on both sides
(metal bushing on front side) and take off the
upper exit roller.
Fig. 13-736
[O] Exit motor
(1) Take off the fuser unit ( Chapter 13.7 [A]).
(2) Take off the IH control PC board with the
whole bracket ( Chapter 13.7 (M-2)).
(3) Remove 2 screws and disconnect 1 connec-
tor and take off the exit motor.
Fig. 13-738
Metal bushing
Spring
Fig. 13-735
(3) Remove 1 connector and take off the IH board
cooling fan.
Note:
When installing, pay attention to the direction
of the wind from the fan.