November 2003 © TOSHIBA TEC 15 - 3 e-STUDIO350/450 POWER SUPPLY UNIT
15
The followings are two output channels which are linked with the door switch.
(1) +5.1V
+5.1VD : CN414 Pin 9
Output to the LGC board
(2) +24V
+24VD1 : CN414 Pins 1 and 2
Output to the LGC board, PFP/LCF (via LGC board)
+24VD1 : CN418 Pin 1
Output to the power supply cooling fan
+24VD2 : CN414 Pins 5 and 6
Output to the LGC board,
Bridge unit / Job separator / Offset tray (via LGC board)
+24VD3 : CN415 Pins 1 and 2
Output to the RADF
+24VD4 : CN415 Pins 9 and 10
Output to the SLG board
+24VD5 : CN416 Pin 3
Output to the finisher
<<Output connector>>
Not linked with the door switch
CN412 For the SYS board
CN413 For the LGC board, FIL board / FUS board, FAX board, PFP/LCF (via LCG
board), Bridge unit / Job separator / Offset tray (via LGC board)
CN415 For the SLG board, RADF
CN416 For the finisher
Linked with the door switch
CN414 For the LGC board, PFP/LCF (via LGC board), Bridge unit / Job separator /
Offset tray (via LGC board)
CN415 For the SLG board, RADF
CN416 For the finisher
CN418 For the power supply cooling fan
To Next Page
Loading...
